BlueWello ACTIVE RO Antiscalant (Works Up to 4000 TDS)
BlueWello ACTIVE RO Antiscalant is a high-performance liquid pretreatment designed to protect Reverse Osmosis (RO) membranes from mineral scaling. Formulated with “Advance Liquid Chemistry,” it effectively handles feed water with up to 4000 TDS, extending your membrane life by up to 50%.
Advantages
-
High-Recovery Efficiency:Specifically formulated to allow RO systems to operate at higher recovery rates, reducing water wastage compared to standard antiscalants.
-
Broad-Spectrum Control:Effectively inhibits a wide range of scales, including Calcium Carbonate, Silica, Iron, and Sulphates, where others often fail on silica.
-
Membrane Longevity:Our “Advance Liquid Chemestry” technology prevents crystal growth on membrane surfaces, extending membrane life by up to 50% and reducing cleaning frequency.
-
Eco-Safe & Biodegradable:Unlike many industrial chemicals, Bluewello uses biodegradable organic polymers that are environmentally responsible.
-
Cost-Effective Dosing:Highly concentrated formula—requires lower dosage (typically 2–4 ppm) than traditional SHMP-based products, saving you money per liter treated.
Suggested Dosage
| Feed Water TDS (ppm) | Recommended Dosage (ml per 1000L of Feed) | Dilution Ratio (with RO Water) |
| Up to 1,000 | 2.0-3.0 ml | 1.10 |
| 1,000-2,500 | 3.0-4.5 ml | 1.10 |
| 2,500-4,000 | 4.5-6.0 ml | 1.5 |
| Above 4000 | Consult Technical Support | Use Neat (Undiluted) |
Technical Specification
| Appearance | Clear to Light Amber Liquid |
| pH (as is) | 4.0 – 5.0 |
| Specific Gravity | 1.10 – 1.20 |
| Solubility | Completely Soluble in Water |
Instructions for Use
- Handling
- Wear protective gloves and eye protection.
- Avoid direct contact with skin and eyes.
- Wash hands thoroughly after handling.
- Safety
- Use in a well-ventilated area.
- In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
- If swallowed, do not induce vomiting; seek medical attention immediately.
- Storage
- Store in a cool, dry place away from direct sunlight.
- Keep container tightly closed when not in use.
- Store away from incompatible materials such as strong acids and oxidizers.
- Doses (2-5 ppm)
- The recommended dose of BlueWello ACTIVE RO Antiscalnt is 2-5 ppm (please refer the table).
- Adjust dosing based on water quality and system requirements suggested in adjacent dosage table.
- Solution Preparation
- Dilute the required amount of BlueWello ACTIVE in clean RO Permeate/Product water before adding to the system.
- Mix thoroughly to ensure a uniform solution.
- Instream Feeding
- Add the prepared solution directly to the feedwater stream.
- Ensure consistent dosing using a metering pump for optimal performance.
The BlueWello Promise
MSF Certified Membrane Safe Formulation
-
Reduces CIP (Cleaning-In-Place) Costs
-
Non-Toxic & Non-Flammable
- 100% Membrane Protection
Reviews
There are no reviews yet.